Registering Your Handset - BT Quartet 1000 User Manual

Quartet 1000 – Edition 3 – 5/9/00 approved
2 Connect the power supply unit into a
convenient mains socket
3 Place the handset on the charging unit
Make sure the red CHARGING light at the front
of the charging unit comes on.
4 Leave the handset to charge for 24 hours
When fully charged and in good condition, the
handset will provide up to 7 hours talktime or
72 hours standby.
If the handset battery is running low, the IN
USE/BATTERY LOW light will flash every
10–15 seconds.
If you are making a call and the handset
battery is running low you will hear a warning
tone every 10–15 seconds.

Registering your handset

You must register your Quartet additional
handset before it can be used with your Quartet
base unit. Make sure that each additional handset
is registered with a different number (2, 3 or 4)
so it can be identified from other additional
handsets, see page 3.
The Quartet 1500 does not feature a PAGE
button. When registering an additional handset
to a base unit please use the base unit
INTERCOM button.
To register an additional handset
Page
• Place the handset you wish to register on the
base unit and then remove it.
• Press and hold the base unit PAGE button for
5 seconds until both the POWER/IN USE light
on the base unit and the IN USE/BATTERY
LOW light on the handset begin to flash.
• Release the PAGE button and press the TALK
button on the handset.
• Your additional handset is registered
automatically and you will hear a long
confirmation beep and the IN USE light will
stop flashing.
2