Breville the Barista Express BES870 Instruction Booklet page 15

PAge heAder..... CARE & CLEANING
Concentrated Solution (for harder water)
• 1 part white vinegar
• 1 part cold tap water
WARNING
Do not immerse power cord, power
plug or appliance in water or any other
liquid. The water tank should never be
removed or completely emptied during
decalcifying.
dECALCIFyING THE MACHINE
• Remove the portafilter and frothing
attachment. Pour the mixture of white
vinegar and water into the water tank.
• Plug the machine into the power outlet
and switch On.
• Press the POWER button to the On
position.
• Place a large container under the group
head and steam wand.
• When the brewing temperature has been
reached all the button surrounds on
the control panel will illuminate. Press
and hold the 1 CUP or 2 CUP button to
commence manual pour. Release the
button once half the mixture of white
vinegar and water has run through the
group head.
• Set the steam dial to the STEAM position
and allow steam to run through the Steam
Wand for approximately 2 minutes. Return
the steam dial back to the STANDBy
position.
• After decalcifying, remove the water
tank and rinse thoroughly then refill
with fresh cold water. To rinse the
machine, repeat previous steps.
28
CARE & CLEANING PAge heAder.....
CLEANING THE CONICAL BURR GRINdER
This grinder cleaning cycle removes oil build-up on the burrs which can impede
performance.
1 2 3 4
POWER GRIND AMOUNT FILTER SIZE
Unlock hopper Empty hopper Replace hopper Lock hopper
8 9 10 11
Unlock top burr Remove top burr Clean burr with brush Clean lower burr with
cleaning brush
AdvANCEd CLEANING FOR THE CONICAL BURR GRINdER
This step is only required if there's a blockage between the grinding burrs and the grinder outlet.
1 2 3 4
GRIND SIZE
LOOSEN NUT
POWER GRIND AMOUNT FILTER SIZE
Remove hopper Set 'GRIND SIZE' to '1' Use 10mm socket. Rotate Set 'GRIND SIZE' to '16'
(finest) 'Clockwise' to remove nut (coarsest)
8 9 10 11
SINGLE DOUBLE
3
2
PUSH TO GRIND
1
1. FELT WASHER
2. METAL WASHER
3. GRIND FAN
Unblock the grinds exit Clean chute with brush Insert grind fan & washers Insert Lower Burr (drive pin
chute using the cleaning using long nose pliers & cavity to align). Insert
brush or a pipe cleaner flat washer & spring washer
WARNING
Care should be taken as the
grinder burrs are extremely sharp.
5 6 7
SINGLE DOUBLE
PUSH
POWER GRIND AMOUNT
Run grinder empty Unlock hopper Remove hopper
12
SINGLE DOUBLE
PUSH TO GRIND
Clean chute with brush
5 6 7
1
GRIND SIZE
2
3
1. GRIND FAN
2. METAL WASHER
3. FELT WASHER
Remove top burr Before removing the lower Remove grind fan & washers
burr, loosen nut & remove using long nose pliers
spring & flat washer
12 13 14
GRIND SIZE
TIGHTEN NUT
Rotate 'Anti-clockwise' to Insert top burr Set 'GRIND SIZE' to '5'.
tighten nut Insert hopper
FILTER SIZE
29