Garmin EDGE 510 Quick Manual page 9

installing the cadence sensor
cadence is your rate of pedaling or "spinning" measured by the
number of revolutions of the crank arm per minute (rpm).
1. select the band size that fits your crank arm
band you select should be the smallest one that stretches across
the crank arm.
2. on the non-drive side, place and hold the flat side of the cadence
sensor on the inside of the crank arm.
3. Pull the bands
2
hooks on the sensor.
3
4. rotate the crank arm to check for clearance. the sensor and
bands should not contact any part of your bike or shoe.
5. take a 15 minute test ride and inspect the sensor and bands to
ensure there is no evidence of damage.
BluetootH settinGs (optional)
the eDGe device has Bluetooth connected features for your compatible smartphone or fitness device
®
(excluding edge touring). some features require you to install Garmin connect mobile on your smart-
phone (for more information, see chapter 2, p. 11). Based on your eDGe
allows you to use following features: livetrack, Weather updates, smart notifications, device to device
transfers and any Garmin connect mobile's feature.
1.
1. select
cHaPter 1: Basic setuP
around the crank arm, and attach them to the
2.
2. select Bluetooth
securely. the
1
NOTE: The LED flashes
green for five seconds to
indicate activity after two
revolutions.
model, Bluetooth connection
®
3.
3. if it is not enabled, select
enable.
TIP: You can select friendly
name to enter a name
that identifies your device
with Bluetooth wireless
technology.
9