JLG 600SJ Service And Maintenance Manual page 279

Table 6-3. Machine Configuration Programming Information Prior to Software Version P5.3
Configuration Digit
GEN SET CUTOUT:
12*
* Only visible if Gen Set /
Welder Menu selection is not 0.
H & T LIGHTS:
13
CABLE SWITCH:
14*
* Only visible under certain
model selections.
* Certain market and model
selections will alter the default
setting.
LOAD SYSTEM:
15*
* Only visible under certain
model selections.
* Certain market selections will
limit load system options or
alter default setting.
LOAD SENSOR:
16*
* Only visible if Load Sensor
Menu selection is not 0.
* Market selections will limit
certain load sensor options.
FUNCTION CUTOUT:
17*
* Only visible under certain
market selections.
* Certain market selections
will limit function cutout options
or alter default setting.
3121202
Number
0 MOTION ENABLED: Motion enabled when generator is ON.
1 MOTION CUTOUT: Motion cutout in platform mode only.
0 NO: No head and tail lights installed.
1 YES: Head and tail lights installed.
0 NO: No broken cable switch installed.
1 YES: Broken cable switch installed.
0 NO: No load sensor installed.
1 WARN ONLY: Functions in creep, overload lamp lit, platform alarm beeps (5 sec ON, 2
sec OFF).
2 CUTOUT PLATFORM: All functions cutout, overload lamp lit, platform alarm beeps (5
sec ON, 2 sec OFF).
3 CUTOUT ALL: All functions cutout, flash overload light (500mS on, 500mS off), platform
alarm beeps (5 sec ON, 2 sec OFF).
4 SPECIAL 1: Functions in creep, overload lamp lit, disables main telescope out & main lift
up, platform alarm beeps (5 sec ON, 2 sec OFF).
0 1 ON ROTATOR: Use the on-board load sensor for all models except those which use the
Leveling Platform Module.
1 4 UNDER PLATFORM: Use the EIM for load sensing.
0 NO: No drive cutout.
1 BOOM CUTOUT: Boom function cutout while driving above elevation.
2 DRIVE CUTOUT: Drive cutout above elevation.
3 DRIVE CUT E&T: Drive cutout above elevation and tilted.
SECTION 6 - JLG CONTROL SYSTEM
Description
– JLG Lift –
Default Number
0
0
0
0
1
0
6-33