Convert All Bar Codes To Code 39; Convert Code 39 To Full Ascii - Motorola DS6878 Product Reference Manual

11 - 6 DS6878 Product Reference Guide

Convert All Bar Codes to Code 39

By default, the Wand Emulation interface sends data to the attached host in the same symbology that was
decoded. This can be a problem for customers with older systems that do not recognize newer symbologies
(for example, GS1 DataBar).
Enabling this parameter ignores the original symbology decoded, and outputs the data as if it were a Code 39
bar code. Any lowercase characters in the original data stream are transmitted as uppercase characters. This
also allows ADF rules.
If Ignore Unknown Characters is enabled, any characters that do not have a corresponding character in the
Code 39 symbology set are replaced by a space.
If Ignore Unknown Characters is disabled, if any characters that do not have a corresponding character are
encountered, the digital scanner emits an error beep and no data is transmitted.
NOTE ADF Note: By default, the Wand Emulation interface does not allow scanned data to be processed by ADF
rules. Enabling this parameter has the side effect of allowing the scanned data to be processed by the
ADF rules (see
Enable Convert to Code 39 for Wand Host

Convert Code 39 to Full ASCII

By default, any characters that do not have a corresponding character in the Code 39 symbology set are
replaced by a space. If this parameter is enabled, the data sent to the wand interface is encoded in Code 39
Full ASCII. This setting requires that the host be able to interpret Code 39 Full ASCII data.
This setting applies only if Convert to Code 39 is also enabled.
*
Disable Code 39 Full ASCII Conversion
Chapter 16, Advanced Data Formatting).
*
Disable Convert to Code 39 for Wand Host
Enable Code 39 Full ASCII Conversion