Ultrabright Data Display Brightness - Cobra XRS 9340 Operating Instructions Manual

10214_XRS9340_PH2_b.c.qxd 7/17/07
Understanding Radar and Laser
Your Detector
Strobe Alert
Special strobes mounted on the light bars of authorized emergency
vehicles (fire trucks, police cars, ambulances) automatically change traffic
signals as the vehicle approaches an intersection. These strobes and the
special strobe detectors located on the traffic signals, introduced fairly
recently by 3M and Tomar, are already in use in more than 1000 cities
nationwide. Cobra's exclusive Strobe Alert detector will detect these
special strobes and give an emergency vehicle alert.
When you receive such an alert, please watch for an approaching
emergency vehicle and pull over to allow it to pass. To inquire about
coverage in your area, contact your local fire and police departments.
LIDAR (Laser)
The correct name for the technology that most people refer to as
laser is actually LIDAR, which stands for Light Detection and Ranging.
LIDAR operates much like radar. Its signal spreads out like a radar
signal, though not as widely. Unlike radar, LIDAR must have a clear
line of sight to its target vehicle throughout the entire measurement
interval. Obstructions such as sign posts, utility poles, tree branches,
etc., will prevent valid speed measurement.
Some common questions about LIDAR include:
■ Does weather have any affect on LIDAR?
Yes. Rain, snow, smoke, fog, or airborne dust particles will reduce the
effective range of LIDAR and can, if dense enough, prevent its operation.
■ Can LIDAR operate through glass?
Yes. Newer LIDAR guns can obtain readings through most types of glass.
However, the laser pulse also can be received through glass to trigger
an alarm by your detector.
■ Can LIDAR operate while in motion?
No. Because LIDAR operates by line of sight, the person using it cannot
drive the vehicle, aim and operate the gun all at the same time.
■ Is LIDAR legal to use?
Yes. It is legal in all 50 states.
18 English
10:33 AM Page 7
Settings
Your Detector

UltraBright Data Display Brightness

You can choose from three settings for Brightness of the display.
You can cycle through the settings by repeatedly pushing the Dim button.
The factory setting is Bright.
Bright
Press and
release Dim
Dark
button
Dim
Dim Button
Press and release
To Change the Brightness to Dim
Press and release
Tone
the Dim button
One beep
once.
To Change the Brightness to Dark
Press and release
Tone
the Dim button
One beep
again.
To Change the Brightness to Bright
Press and release
Tone
the Dim button a
Two beeps
third time.
Visual Display
Display dims
Visual Display
Display remains dim
(no visual alerts will be seen)
Visual Display
Display returns
to full brightness
Nothing Comes Close to a Cobra ® 7