Cobra XRS 9340 Operating Instructions Manual page 13

10214_XRS9340_PH2_b.c.qxd 7/17/07
Detection
Your Detector
Radar Signals and Visual Displays
Type of Signal
X Band Radar
K Band Radar
Ka Band Radar
Ku Band Radar
X Signal Detected K Signal Detected
2
X K Ka V S X K Ka V S
Laser Signals and Visual Displays
Type of Signal
LTI 20-20*
LTI Ultra-Lyte*
Kustom Signals ProLaser*
Kustom Signals ProLaser III*
* Your detector provides 360˚ detection of these signals.
Laser Signal Detected
L
X K Ka V S
NOTE
Beep rate changes with different laser alerts.
14 English
10:33 AM Page 11
Visual Display
X and Signal Strength
K and Signal Strength
Ka and Signal Strength
X K and Signal Strength
Ka Signal Detected Ku Signal Detected
3 5 4
X K Ka V S X K Ka V S
Visual Display
L is Steady
L is Steady
L is Steady
L is Steady
Settings
Your Detector
IntelliMute Button
Press and hold for
two seconds
To Set the IntelliMute Activation Point
Press and hold Tone
the IntelliMute
Two beeps
button for two
seconds.
Rev your engine to None
the level you wish
to set (recommend
slightly above idle)
and hold revs steady
for two seconds.
At the desired Three beeps
rev level, press
and release the
IntelliMute
button.
NOTE
If the unit is unable to sense usable pulses within three
seconds or if you do not set a rev point within 20 seconds
of beginning these steps, IntelliMute will indicate an error
and automatically turn Off.
Tone
Four beeps
Visual Display
None
Three bars will
flash in succession
1 2 3
All three bars flash
three times
1 2 3
Visual Display
E appears
E
X K Ka V S
Nothing Comes Close to a Cobra ® 11