Samsung SNB-3002 User Manual page 92

appendix
PROBLEM
<Motion detection> of <Event
setup> is set to <Enable>, but
no notification e-mail reaches me
even when an event had occurred.
No signal is found at the Alarm
Output port even when an event is
generated.
Cannot record into the SD memory
card.
SD memory card is inserted but
the camera does not operate
properly.
Cannot format the SD memory
card.
92_ appendix
y Verify the settings in the following sequence:
A. Check <Data & Time> settings.
B. The <Motion detection> should be set to <Enable>.
C. Check if the <E-mail> option of <Event action setup> menu is
checked to use.
y Check alarm output port settings.
y Check if the memory card is defective.
y Check if the write protection tab of the memory card is set to "LOCK".
y Check if the memory card is inserted in the proper direction. Operation
of memory card that is formatted by other devices is not guaranteed with
this camera unit
y Format the memory card again in <Setup>  <Event>  <Storage>
menu.
y Check if the write protection tab of the memory card is set to "LOCK".
SOLUTION