Installing the LED Board
1.
Insert the LED board into its slot on the palmrest.
2.
Tighten the screw that secures the LED board to the palmrest.
3.
Connect the LED-board cable to its connector on the LED board.
4.
Install the:
a.
palmrest
b.
keyboard
c.
keyboard trim
d.
battery
e.
base cover
5.
Follow the procedures in
Removing the Power-Connector Port
1.
Follow the procedures in
2.
Remove the:
a.
base cover
b.
battery
3.
Perform the following steps:
a. Release the power-connector port cable from its routing channels [1].
b. Remove the screws to release the metal bracket that secure the power-connector port [2].
c. Remove the metal bracket to access the power-connector port [3].
22
After Working Inside Your
Before Working Inside Your
Computer.
Computer.