DeWalt DCV581H Instruction Manual
  1. Manuals
  2. Brands
  3. DeWalt Manuals
  4. Vacuum Cleaner
  5. DCV581H
  6. Instruction manual

DeWalt DCV581H Instruction Manual

Dewalt dcv581h 18v nicd/20 v max li-ion 2-gallon corded/cordless wet/dry vacuum
Hide thumbs Also See for DCV581H:
Table of Contents

Advertisement

Quick Links

See also: Instruction Manual
INSTRUCTION MANUAL
DCV581H
18V NiCd/20 V Max* Li-Ion 2-Gallon Corded/Cordless Wet/Dry Vacuum

Advertisement

Table of Contents
loading

Related Manuals for DeWalt DCV581H

Summary of Contents for DeWalt DCV581H

  • Page 1 INSTRUCTION MANUAL DCV581H 18V NiCd/20 V Max* Li-Ion 2-Gallon Corded/Cordless Wet/Dry Vacuum...

  • Page 2: Defi Nitions: Safety Guidelines

    • Instructions for compatible batteries and chargers are included Defi nitions: Safety Guidelines for reference in this manual. Read all instruction manuals included with your battery or charger. Read all cautionary markings on the The definitions below describe the level of severity for each charger and battery.

  • Page 3: Additional Safety Rules

    • Keep hair, loose clothing, fingers, and all body parts away from the • Avoid accidental starting. Be sure the switch is in the OFF position openings and moving parts. before inserting the battery pack or plugging the vacuum into a wall outlet.

  • Page 4: Double Insulation

    Polarized Plugs Minimum Gauge for Cord Sets Volts Total Length of Cord in Feet (meters) Polarized plugs (one blade is wider than the other) are used on Ampere Rating 120V 25 (7.6) 50 (15.2) 100 (30.5) 150 (45.7) equipment to reduce the risk of electric shock. When provided, this plug will fit in the polarized outlet only one way.

  • Page 5: Important Safety Instructions For All Battery Packs

    BPM ..... beats per minute n ......rated WARNING: Use of this tool can generate and/or disperse dust, IPM ....impacts per minute ......speed which may cause serious and permanent respiratory or other injury. Always use NIOSH/OSHA approved respiratory protection RPM ..... revolutions per .....earthing appropriate for the dust exposure.
  • Page 6 NOTE: Do not store the battery pack in the vacuum with the damage the slide battery pack. Do not use a slide battery pack or trigger switch locked on. Never tape down the on/off button in the charger that has received a sharp blow, been dropped, run over or ON position.

  • Page 7: Important Safety Instructions For All Battery Chargers

    • Contents of opened battery cells may cause respiratory amount of work. To use the automatic Tune-Up™, place the battery irritation. Provide fresh air. If symptoms persist, seek medical pack in the charger and leave it for at least 8 hours. The charger will attention.
  • Page 8 NOTICE: Under certain conditions, with the charger plugged into overheating. When using more than one extension to make up the the power supply, the charger can be shorted by foreign material. total length, be sure each individual extension contains at least the Foreign materials of a conductive nature, such as, but not limited to, minimum wire size.

  • Page 9: Charge Indicators

    • NEVER attempt to connect 2 chargers together. 3. The completion of charge will be indicated by the red light remaining ON continuously. The pack is fully charged and may • The charger is designed to operate on standard 120 volt be used at this time or left in the charger.

  • Page 10: Important Charging Notes

    LEAVING THE BATTERY PACK IN THE CHARGER 4. If the battery pack does not charge properly: The charger and battery pack can be left connected with the charge a. Check operation of the receptacle by plugging in a lamp or indicator showing pack charged.

  • Page 11: Intended Use

    2. For long storage, it is recommended to store a fully charged INTENDED USE battery pack in a cool dry place out of the charger for optimal The vacuum is designed to operate only on a D WALT 18V NiCd/ results.

  • Page 12: Vacuum Cleaning

    Using the Appliance (Fig. 2, 4) NOTE: The machine must be used in the upright position at all times to prevent unwanted actuation of the Automatic Vacuum Shutoff. If 1 Attach the appropriate accessory to FIG. 4 unwanted actuation should happen, turn off the motor and wait until the hose (B).

  • Page 13: Maintenance

    4. Reinstall and secure the filter onto power head by twisting the filter battery interface, and secured with the hose clip (G) also located at to the left. the back of the vacuum. The two accessories (crevice tool and wide nozzle) can be stored on board the vacuum as well.
  • Page 14 DW9072 DW9048 DW9061 DW9062 DW9057 “X” Indicates that the battery pack is not compatible with that specific charger. All charge times are approximate. Actual charge time may vary. Read the instruction manual for more specific information. DeWalt electric Power tools...

Table of Contents