EnGLIsh DUST EXTRACTOR DCV586M Congratulations! You have chosen a D WALT dust extractor. Years of experience, thorough product development and innovation make D WALT one of the most reliable partners for professional power Markus Rompel tool users. Vice-President Engineering, PTE-Europa WALT, Richard-Klinger-Straße 11, Technical Data D-65510, Idstein, Germany DCV586M...
EnGLIsh Specific Safety Rules for Dust Extractors If the supply cord is damaged, it must be replaced by a specially prepared cord available through the D WALT • The appliance may only be used by persons who are familiar service organisation. with it, have been trained on how to use it safely and who Mains Plug Replacement understand the resulting hazards.
EnGLIsh • DO NOT attempt to charge the battery pack with any nOTE: To ensure maximum performance and life of lithium-ion chargers other than the ones in this manual. The charger battery packs, charge the battery pack fully before first use. and battery pack are specifically designed to work together.
Page 9
EnGLIsh an optimal depth leaving approximately 5.5 mm of the screw damaged in any way (i.e., pierced with a nail, hit with exposed. Align the slots on the back of the charger with the a hammer, stepped on). Electric shock or electrocution exposed screws and fully engage them in the slots.
EnGLIsh Transporting the Example of Use and Transport Label Marking Have defective cords replaced immediately. FLEXVOLT Battery The D WALT FLEXVOLT battery has two modes: Charge only between 4 ˚C and 40 ˚C. Use and Transport. Use Mode: When the FLEXVOLT battery stands alone or is in Only for indoor use.
EnGLIsh Markings on Dust Extractor Intended Use This industrial dust extractor cleaner is intended for wet and dry The following pictograms are shown on the dust extractor: vacuum cleaning applications. The appliance can operate cordless by using the D WALT 54V Read instruction manual before use.
EnGLIsh Fuel Gauge Battery Packs (Fig. B) 4. Rotate the bag until the two tabs align with the two notches on the dust extractor and remove the bag from the Some D WALT battery packs include a fuel gauge which dust extractor.
Page 13
EnGLIsh Connecting to Power Tools (Fig. A, G) 4. To turn dust extractor on, press the three position switch 3 to the On (I) position. CAUTION: Follow all the requirements of the power tool 5. To use in Wireless Tool Control mode press the three position regarding connection of dust extractor.
Dispose of filter in appropriate container according to extractor on the bottom. statutory provisions. The DEWALT TSTAK stacking latches l allow for other To Install Filters (Fig. E, F, I) TSTAK products to securely stack one on top of the other for convenience and portability.
EnGLIsh Storage (Fig. A) WARNING: To reduce the risk of serious personal injury, turn dust extractor off and disconnect battery CAUTION: The three position switch must be in OFF (0) pack before making any adjustments or removing/ position to prevent unintentional being switched on by installing attachments or accessories and if the Wireless Tool Control.
EnGLIsh Fleece filter bag: The DCV9402 fleece bag is designed to capture many types of dust including drywall, concrete and wood. This bag should be disposed of once the airflow becomes restricted. DO NOT reuse this bag. The fleece bag is ideal for heavier materials such as concrete and drywall dust where a paper filter bag may tear.
EnGLIsh TROUBLESHOOTING Problem Possible cause Troubleshooting steps Motor does not run. Switch is not in On (I) position. Ensure three position switch is in On (I) position. Low battery voltage/poor battery connection. Ensure battery is fully charged and fully inserted. Tank is full of liquid and sense circuit is tripped.