Kyocera FS-9530DN Service Manual page 49

Maintenance
item No.
Setting: adjustment of front/rear side registration home position
U246
1. Select [>>Width F HP] or [>>Width R HP].
2. Press the OK key. [ _ ] will blink.
3. Press the cursor right/left keys to move [ _ ] to the digit position at which the value is to be changed and
press the cursor up/down keys to change the preset value.
Setting range: -10 to 10
Initial setting: 0
Change in value per step: 0.31 ms
4. Press the OK key. The value is set.
To keep the preset value, press the CANCEL key.
Setting: adjustment of front and back stapling home position
1. Select [>>Staple HP].
2. Press the OK key. [ _ ] will blink.
3. Press the cursor right/left keys to move [ _ ] to the digit position at which the value is to be changed and
press the cursor up/down keys to change the preset value.
Setting range: -10 to 10
Initial setting: 0
Change in value per step: 0.32 ms
When staple positions are off toward the front side of the machine (sample 1), increase the preset value.
When staple positions are off toward the rear side of the machine (sample 2), decrease the preset
value.
4. Press the OK key. The value is set.
To keep the preset value, press the CANCEL key.
Setting: adjustment of slanted stapling home position
1. Select [>>T-Staple HP].
2. Press the OK key. [ _ ] will blink.
3. Press the cursor right/left keys to move [ _ ] to the digit position at which the value is to be changed and
press the cursor up/down keys to change the preset value.
Setting range: -10 to 10
Initial setting: 0
Change in value per step: 0.99
To increase the angle for slanted stapling (sample 1), decrease the preset value. To decrease the angle
for slanted stapling (sample 2), increase the preset value.
4. Press the OK key. The value is set.
To keep the preset value, press the CANCEL key.
Description
Sample 1
Figure 1-3-3
°
Sample 1
Figure 1-3-4
Sample 2
Sample 2
2GZ/2G1
1-3-17