Detaching And Refitting The Drum Separation Claws - Kyocera FS-9530DN Service Manual

2GZ/2G1-2

(3) Detaching and refitting the drum separation claws

Follow the procedure below to replace the drum separation claws.
Procedure
1. Remove the developing unit (see page 1-5-
17).
2. Remove the drum unit (see page 1-5-14).
3. Remove two screws and remove the lower
cleaning seal.
4. Release the inserted part and remove the
drum separation claws from the lower clean-
ing seal.
5. Replace the drum separation claws and
Install the claws.
6. Refit the lower cleaning seal to the drum
unit.
7. Refit the drum unit and developing unit.
1-5-16
Figure 1-5-36
Lower
cleaning seal
Drum separation
claw
Figure 1-5-37
Drum unit
Lower
cleaning seal
Lower
cleaning seal