Table of Contents
Advertisement
4026-0XX
Fuse F1 continues to open after being replaced
FRU
1
Fuse F1
2-24
Action
If fuse F1 continues to open after being
replaced, disconnect CN7 from the engine
board and turn the printer power on. If F1 opens,
replace the LVPS.
If F1 does not open with CN7 disconnected,
check the following:
Turn the printer power off and disconnect all the
cables connected to the engine board and
remove the controller board. Reconnect each
cable and the controller board one at a time until
the FRU causing F1 to open is found. Replace
the failing FRU.
Advertisement
Table of Contents
