Error Conditions - Lexmark J110 User Manual

Error conditions

What shows on the four
indicator lights
binary 12 (for 0.25 sec),
binary 3 (for 0.25 sec),
repeat continuously.
binary 15 (for 0.25 sec),
binary x (for 0.25 sec),
repeat continuously.
where x could be 0, 1, 2, 3,
4, 5, 6, 7, 8, or 9
binary 9 (for 0.75 sec),
binary 1 (for 0.75 sec),
repeat continuously.
binary 9 (for 0.75 sec),
binary 1 (for 0.75 sec),
repeats for a few seconds,
then the print server
automatically resets its
serial port (attempts to
recover). The two parallel
ports are unaffected.
Description
Serious failure.
The print server is unable
to recover.
POST error
Serial error
Type = Parity
Serial error
Type = Parity
110
Cause and solution
Flawed firmware in print server or power interruption
during flash operation.
Call Customer Support.
Power-on self test error. During start-up, a hardware
failure was detected on the print server.
1
Reset the print server.
2
If the problem reoccurs, call Customer Support.
Parity error occurred during serial print job.
1
Reset the print server. (The 9,1 error code does
not go away until you reset the print server. This is
to make sure you see that a parity error occurred.
To turn parity checking off, use a utility or telnet to
port 9000.)
2
Send the job again.
Serial settings for print server do not match serial
settings for printer.
• Change the serial port settings for either the print
server or the printer so they match.
The printer was turned off while the serial job was
printing.
1
Turn the printer back on. The print server then
flushes the current job.
2
Send the job again.