Tv Antenna - Winnebago Voyage 2005 User Manual

Table of Contents

Advertisement

CAUTION
Swing-out TV mounts are not
intended for viewing while the vehi-
cle is in motion. If your model is
equipped with a swing-out TV
mount, the TV should be stowed and
latched while traveling.
HOME THEATER SYSTEM -
Optional
The home theater system operates from 110V
AC household current only, so you must have ei-
ther the shoreline plugged in, or the generator
running or the inverter turned on.
NOTE: Batteries will deplete quickly with use of
the inverter. The inverter is intended for
limited, short term TV/Video use while
the vehicle is in motion or while not con-
nected to shoreline or generator power.
It is not intended for steady use while
'dry camping'.
The sound from this system emits from the
five high-output surround sound cube speakers
located near the ceiling. These speakers are not
connected to the dash radio speakers.
Refer to the manufacturer's operating guide
for complete operation and troubleshooting in-
formation.
Video Selector Panel Settings
To Watch Broadcast TV (Antenna)
Press TV ANT button on MAIN TV section
of Video Selector Panel.
To Watch Cable TV
Press CABLE TV button on MAIN TV sec-
tion of Video Selector Panel.
To Watch Satellite TV (Dish)
Press SAT button on MAIN TV section of
Video Selector Panel.

TV ANTENNA

The TV antenna on your motor home can be
easily raised, rotated a full 360° and lowered
from inside the vehicle by simply turning a crank
or rotating knob. A built-in signal amplifier de-
signed to strengthen signals, is controlled by a
power switch built into the TV jack assembly.
The signal amplifier is housed inside the an-
tenna with the circuit board connected directly to
the antenna elements. Power to operate the am-
plifier (12-volt DC) is supplied through the
downlead cable which also carries the TV signals
to the TV set. The power supply separates the 12-
volt DC from the TV signals and provides a place
for attaching the TV set and the 12-volt power
source.
Operation
Raising Antenna - Turn elevating crank
clockwise in "UP" direction or until some resis-
tance to turning is noted. Antenna is now in oper-
ating position. Turn amplifier power switch
"ON" to receive TV signal.
SECTION 11
ENTERTAINMENT
11-3

Advertisement

Table of Contents
loading

Table of Contents