Table of Contents
Advertisement
Water Heater Drain Plug:
heater drain plug is located on the outside of the
coach behind the water heater service panel. Use
a socket to remove the plug.
Drain
Plug
Water Heater
Service Access
WINTERIZING PROCEDURE
1. Clean and dump holding tanks by following
steps A, B, and C
A.
Add water to the sewage holding tank
by holding the toilet flush lever open
with the water pump running. Add
water to the waste water holding tanks
by opening the kitchen, shower and lav-
atory faucets. Tanks should be about 1/
4 to 1/3 full to rinse properly. Driving to
a disposal site will normally loosen and
rinse any waste material from the sides
of the tank.
B.
Completely drain the sewage and waste
water holding tanks at an approved
waste disposal site. Drain the sewage
tank first so the following waste water
can rinse any waste solids from the
dump outlet and sewer hose.
C.
Close dump valves and refit the dust cap
onto the drain outlet.
2. Level the motor home and drain the entire
plumbing system as described in the follow-
ing steps.
3. Then turn on Wash Station Shower Head and
lay shower head on ground to drain any
water left in shower line. Also place the tip
The water
4. Remove the water filter cartridge
PLUMBING SYSTEMS
of your finger into the city water inlet and
gently press the backflow valve "button" in
the center of the inlet to drain any water left
in the stub line.
•
Raise the valve handle on the filter base.
•
Twist the filter cartridge counterclock-
wise about 90° and pull it down and out
of the filter base.
•
Place a container beneath the filter base
and lower the valve handle to drain any
water remaining in the filter lines.
Water Filter Assembly -
Below Galley Sink
SECTION 10
10-9
Advertisement
Table of Contents
