Sony HDW-730 Operation Manual page 326

When removing the remote control unit from the camcorder
The setting of the camcorder returns to the setting in effect before the
remote control unit was connected.
By setting the menu setting, the setting of the paint adjustment made
with the remote control unit can be retained even after the remote
control unit is removed from the camcorder.
For details, see "Structure of the paint adjustment data" on the next page.
When connecting the monitor to the MONITOR OUT
connector of the remote control unit
5
The MONITOR connector of the RM-B150 (BNC type) outputs the
same signal as that from the TEST OUT connector on the camcorder.
When the HKDW-702 is installed, you can also connect an NTSC
monitor.
When you connect the HD monitor, select the HD-Y signal as the output
signal from the TEST OUT connector on the OUTPUT SET page of the
USER menu.
When connecting an NTSC monitor, select the SD signal (analog
composite video).
For details, see "4-8-2 Selecting the Output Signals" on page 4-101.
Use the black cable supplied with the RM-B150 to connect the monitor
to the MONITOR connector on the RM-B150.
5-38
Chapter 5 Setting Up the Camcorder