Connect Using Wcn 2.0 In Windows Vista - D-Link DIR-685 Xtreme N User Manual

Secton  - Securty

Connect Using WCN 2.0 in Windows Vista

®
The router supports Wi-Fi protection, referred to as WCN 2.0 in Windows Vista . The following instructions for setting
®
this up depends on whether you are using Windows Vista to configure the router or third party software.
®
When you first set up the router, Wi-Fi protection is disabled and unconfigured. To enjoy the benefits of Wi-Fi protection,
the router must be both enabled and configured. There are three basic methods to accomplish this: use Windows Vista's
built-in support for WCN 2.0, use software provided by a third party, or manually configure.
If you are running Windows Vista , log into the router and click the Enable checkbox in the Basic > Wireless section.
®
Use the Current PIN that is displayed on the Advanced > Wi-Fi.Protected.Setup section or choose to click the Generate.
New.PIN button or Reset.PIN.to.Default button.
If you are using third party software to set up Wi-Fi Protection, carefully follow the directions. When you are finished,
proceed to the next section to set up the newly-configured router.
D-Lnk DIR-685 User Manual 8