Table of Contents
Advertisement
same way, i.e. with the preprinted side face up and the top edge of the page facing
toward the rear of the printer.
4.5.7 Universal Size
A paper size of Universal is displayed in the printer menu when a non-standard size
paper is detected in an auto size sensing tray or Universal is selected in the IPDS
PAPER HANDLING menu as the paper size loaded into a non-size sensing tray or
feeder. This option allows you to specify the paper size returned to the host when a
non-standard paper size is loaded. The paper size is specified in 300 dots per inch.
Important:
The default paper size value returned to the host is 215.9 x 355.6 mm
(8.5 x 14.0 in.). A 34 Short Paper error will be displayed if printing
occurs past the length of the physical paper. You should specify the
actual paper size to avoid this error.
Note:
This option is only available on IPDS code level 9241 or above.
Menu Option
Value Range
Paper Length
4200*, 1500 to 4200
Paper Width
2550*, 825 to 2703
Note:
The printer paper trays and feeders are limited to feeding of specific
paper sizes. The IPDS paper length and width selectable range is
from the smallest to largest size paper which can be fed through the
printer. Refer to your printer documentation when loading a non-
standard paper size to determine if that paper size can be fed from
that tray or feeder.
Conversion example:
52
Function
Specifies Universal paper length. See note below.
Specifies Universal paper width. See note below.
Advertisement
Table of Contents
