Universal Setup; Reports - Lexmark X644E Menus And Messages Manual

Universal Setup

These menu items are used to specify the height and width of the Universal Paper Size. By specifying the height and width
for Universal Paper Size, the MFP uses the Universal setting like other paper sizes, including support for duplex and n-up.
For more information on n-up, see Multipage Print.
Menu item Purpose
Units of Measure Determines the unit of measure
used to enter the Universal Height
and Width.
Portrait Width Sets the portrait width of the
universal media.
Note: If the value set exceeds the
maximum width, the MFP uses the
maximum value allowed in inches or
millimeters.
Portrait Height Sets the portrait height of the
universal media.
Note: If the value set exceeds the
maximum height, the MFP uses the
maximum value allowed in inches or
millimeters.
Feed Direction Specifies the feed direction of the
Universal Paper Size.

Reports

Note: After a report prints, the MFP returns to the home screen.
Using MFP menus
Values and descriptions
Inches
Millimeters
3 inches to
14.17 inches in 0.01
inch increments
76 mm to 360 mm in
1 mm increments
3 inches to
14.17 inches in 0.01
inch increments
76 mm to 360 in
1 mm increments
Short Edge*
Long Edge
Reports
25
Inches is the US default, and
Millimeters is the international default.
Shows either inches or millimeters
from Units of Measure setting;
8.5 inches is the US default, and
216 mm is the international default.
Shows either inches or millimeters
from Units of Measure setting;
14 inches is the US default, and
356 millimeters is the international
default.
Feed Direction is only shown if the
Long Edge value is available. Long
Edge exists if the longest edge is
shorter than the maximum physical
width that the tray can accommodate.
See Duplex Bind on page 68 for
more information about short and long
edges.