Operation - Electrolux E36DF76EPS Service Manual

Operation

VERIFYING THE OPERATION
NOTE: REFER TO THE USE AND CARE MANUAL
FOR DETAILED INSTRUCTIONS.
Before beginning the test procedure, ensure that all
cooktop control valves are in the "OFF" position, and all
burner rings, burner caps, and grates are properly
positioned on the top frame. Turn on the gas supply at
the shut-off valve.
Turn on the power supply to the range. Select a tem-
perature of 350°F by rotating the temperature control
knob to "350" and selecting "BAKE" with the oven se-
lector knob. Rotate each knob to the "Off" position to
stop the heating process. For model E48DF76EPS, re-
peat this test procedure with the companion oven. Test
each top burner separately by pressing and turning one
control knob at a time counterclockwise to the "HIGH"
position. All ignitors will spark continuously, but only
the burner with gas flowing to it will ignite. (It will take
approximately 4 seconds for ignition to occur, at which
time the ignitors will stop sparking. If ignition does not
occur within 4 seconds, turn off the knob, wait for at
least 2 minutes to allow any gas to dissipate, then re-
peat this ignition test.) The control knob can then be
rotated counterclockwise from "HIGH" to "LOW" to ad-
just the flame height progressively. Repeat the ignition
test for all burners. When installed properly, the flame
will be steady and quiet. It will also have a sharp, blue
inner cone that will vary in length proportional to the
burner size.
WARNING
• The range and shut-off valve must be
disconnected from the gas supply piping
during any pressure testing exceeding 1/2 psi
(3.5kPa).
• The range must be isolated from the gas supply
piping by closing the shut-off valve during any
pressure testing at or below 1/2 psi (3.5 kPa).
NOTES If either the oven or cooktop does not
operate properly, follow these
troubleshooting steps:
• Verify that power and gas are supplied to
the range.
• Check the electrical connections and gas
supply to ensure that the installation has
been completed correctly.
• If the appliance still does not work,
contact an authorized service company.
Do not attempt to repair the appliance
yourself.
Electrolux is not responsible for service
required to correct a faulty installation.
69