To Properly Position The Wok Stand; Using The Simmer Plate; Setting Surface Controls - Electrolux E36DF76EPS Service Manual

CAUTION
Always use potholders to remove the wok stand
from the grate. Allow the wok stand to cool before
removing. Do not set hot wok stand on surfaces
that cannot withstand high heat; such as
countertops.
Be sure the Wok Stand is positioned correctly and
stable before use to prevent hot spills and possible
burns.

To Properly Position the Wok Stand:

With the grate in position over the burner, set the Wok
Stand on top of the grate positioning the center of the
Wok Stand over the center of the cooktop grate fin-
gers.
NOTE: The Wok cooking performance is best on
the right front or center front POWER
burner position depending on your range
model.
CAUTION
Be sure to ALWAYS use the Wok Stand if the
stability of the wok is uncertain. If cooking large
amounts of liquid food without the Wok Stand,
the wok may tip and spill over causing burns.
Flat-bottom woks with large flat bottoms may also be
used on your cooktop Surface Burner Grates without
the Wok Stand. Insure the stability of the flat-bottom
wok before cooking without the Wok Stand. If unstable,
DO NOT use the flatbottom wok without the Wok Stand.
Round-bottom woks (with a support ring) should
NOT be used. The supporting ring was not designed
for proper or stable use

USING THE SIMMER PLATE

The Simmer Plate has been specfically designed for
simmering and holding food at the lowest safe tempera-
ture. It can be used for cooking sauces long periods of
time, or melting chocolate. With the grate in position
over the burner, set the simmer plate on top of the grate,
centering the plate over the grate fingers.
Then place the utensil on the simmer plate.The Sim-
mer Plate is to be used by setting the burner to its low-
est setting. The Simmer Plate is intended to be used
for simmering only. The Simmer Plate must be removed
when cooking.
CAUTION
Always place the simmer plate on the grate before
turning on the burner.
Always use potholders to remove the simmer plate
from the grate. Allow the simmer plate to cool be-
fore removing. Do not set hot simmer plate on sur-
faces that cannot withstand high heat; such as
countertops.
Be sure the simmer plate is positioned correctly and
stable before use to prevent hot spills and possible
burns.

SETTING SURFACE CONTROLS

Your range may be equipped with any combination of
the following burners:
31
on the
Surface Burner Grates.