Sealed Burner Configurations; Brass Burner Rings; Burn Igniters; Control Knobs - Electrolux E36DF76EPS Service Manual

Cooktop Features

SEALED BURNER CONFIGURATIONS

On E30DF74EPS ranges, there are a total of four burn-
ers, including one burner rated at a maximum output of
17,000 BTU/HR, two burners rated at a maximum of
15,000 BTU/HR and one burner rated at a maximum
output of 8,500 BTU/HR. The knobs are grouped in twos.
The left two knobs operate the left two burners, and the
right two knobs control the two right burners.
On E36DF76EPS and E48DF76EPS ranges, there are
a total of six burners, including two burners rated at a
maximum output of 17,000 BTU/HR, two burners
rated at a maximum of 15,000 BTU/HR and two burn-
ers rated at a maximum output of 8,500 BTU/HR. The
knobs are positioned to correspond with the burner
layout.

BRASS BURNER RINGS

All burners are attached to the cooktop by retaining nuts.
Gaskets around the undersides of the burner bases
ensure that the burners are sealed, thereby preventing
any liquid spills from entering the cooktop chassis. All
spills remain on the surface of the cooktop. The brass
burner heads spread the flame evenly around the burner
perimeters.The burner heads must seat properly in the
burner bases to enable proper cooktop operation. To
ensure proper seating, positioning tabs have been
placed on the bottom of each burner head to slide into
corresponding notches in the fixed burner
base.
BURNER IGNITORS
A burner igniter is located on each gas burner base.
When a control knob is rotated more than 90 degrees
counterclockwise, the ignitor will spark and the selected
burner will ignite. Additionally, due to Vantage Flame™,
the automatic reignition feature, the igniters will spark
automatically if a flame should blow out or be severely
distorted by a draft or by a ventilation system. Burner
igniters must always be kept clean and dry to function
properly. Dirty or wet igniters will result in constant spark-
ing, even if there is a flame present.
PORCELAIN
BURNER CAP
BURNER
BASE
BURNER
IGNITOR
Cooktop Features/Surface Cooking

CONTROL KNOBS

The control knobs provided with this range are designed
for ease of use and longevity. The "D" shaped design of
the knob shaft ensures proper orientation when rein-
stalling the knob. Located beneath each knob is a be-
zel ring that mounts to the range.

PLACEMENT OF BURNER GRATES

Place grates on the porcelain coated spill tray.
Be sure they are located correctly inside the stainless
steel frame.
28
BRASS
BURNER RING
BURNER ASSEMBLY