Setting The Time Code Reader (Tcr Sel); Setting The Time Code Generator (Tcg Source/Mode); Selecting The Time Code Running Mode (Run Mode) - Sony SRW-5000 Operation Manual

To pause the current time
Press the [F4] (TIMER HOLD) button.
The time is paused only while the button is held down.
4-3-2 Setting the Time Code Reader
(TCR SEL)
Press the [F5] (TCR SEL) button to select the time code to
be read by the time code reader during playback.
VITC: Reads VITC.
auto: Reads VITC when the playback speed is ±1/2 times
normal speed or less, and LTC when it is greater than
±1/2 times normal speed.
LTC: Reads LTC.
Depending on the time code recorded on a tape, VITC or
LTC appears on the display.
Note
Time codes that are read by the time code reader or played
back are output from the TIME CODE OUT connector.
4-3-3 Setting the Time Code
Generator (TCG SOURCE/MODE)
There are two ways to record time codes on the VTR. One
way is to record the output of the VTR's internal time code
generator. The other is to directly record time codes that
are input from an external time code generator.
The output from the internal time code generator can either
be set to a specified initial value, or synchronized with an
external time code generator.
The internal time code generator time code settings are
made with the [F6] (REGENE SOURCE)/[F7] (TCG
MODE) buttons. Menu selections and settings are shown
in the following table.
Menu [F6]
(REGENE
TCG SOURCE)
Internal TCG
(Preset)
Internal TCG int-LTC
(Regenerate)
int-VITC
ext-LTC
SDI-V
SDI-L
Note
Regenerated signals are selected using the VTR SETUP
menu item 608 "TCG/UBG REGENE MODE setting".
To check the running of the internal time code
generator
Press the INPUT CHECK button.
4-3-4 Selecting the Time Code
Running Mode (RUN MODE)
Press the [F8] (RUN MODE) button to select the time code
running mode.
free: The time code advances when the power is on
regardless of the VTR's operation mode.
rec: The time code advances only during recording.
[F7] (TCG Setting
MODE)
prst Time codes
can be freely
set using the
internal time
code generator
regene Lock to the
time data
recorded on
the time code
tracks
regene Lock to the
time data
recorded as
video AUX data
on the tape
regene Lock to the
time data on
the TIME
CODE IN
connector
regene Lock to the
VITC time data
in the video
signal from the
HD SDI INPUT
A/B connector
regene Lock to the LTC
time data in the
video signal
from the HD
SDI INPUT A/B
connector
auto "int-LTC/
regene" is set
in assemble or
insert mode
and "prst" is set
in other modes
4-3 TC Menu
59