Settings For External Editors; Time Code Settings For Recorder; Vtr Constant Settings For External Editors; System Phase Adjustment - Sony DNW-A25WS Installation Manual

1-10. Settings for External Editors

1-10-1. Time Code Settings for Recorder

When Editing with an Editor Capable of the 1st-
edit (BVE-2000)
. Time code operation block on the control panel
INT/EXT switch
PRESET/REGEN switch
F-RUN/R-RUN switch
When Editing Directly from VTR to VTR
n
Make sure that the setting of ITEM-610 on the setup menu
is as follows:
. ITEM-610: REGEN CONTROL MODE
. Time code operation block on the control panel
INT/EXT switch
PRESET/REGEN switch
F-RUN/R-RUN switch
1-10-2. VTR Constant Settings for External
Editors
The following constants are standard for each type and
system listed.
When using an external editor which requires the VTR
constants, use the settings listed. VTR constants must also
be set when switching between the 525 and 625 modes.
Operation Mode
VTR CONSTANT 1
525
mode
VTR CONSTANT 2
VTR CONSTANT 1
625
mode
VTR CONSTANT 2
Values are represented in hexadecimal
m
1. Set the data No. 8 of VTR CONSTANT 1 to 0A for
the following editors:
. BVE-900 ROM version 1.08 or lower
. BVE-600 ROM version 1.01 or lower
2. If the unit is controlled by the editor, be sure to set
ITEM-401 on the setup menu as follows:
. ITEM-401: FUNCTION MODE AFTER CUE-UP
DNW-A25WS/A25WSP
8 INT
8 PRESET
8 F-RUN
8 0: auto edit
8 INT
8 PRESET
8 R-RUN
Data No.
1 2 3 4 5 6 7 8
B0 4B 00 96 07 07 04 8B
0A 08 FB 00 8D 3D FF 4C
B1 4B 00 7D 07 07 04 8B
0A 07 FB 00 8F 4B FF 4C
8 0: stop

1-10-3. System Phase Adjustment

An analog composite signal input at the VIDEO REF.IN or
VIDEO INPUT connector of the unit should be within
specifications in SC-H.
In Combination with a Digital Switcher
The system phase adjustment is unnecessary usually.
Refer to the operation manual supplied with the digital
switcher for details.
In Combination with an Analog Switcher
The system phase adjustment for the unit is necessary.
Refer to the operation manual supplied with the analog
switcher for details.

1-10-4. Setup Menu Setting of ITEM-701

When Incorporating the Unit Into an Editing
System
Set ITEM-701 on the setup menu as follows:
. ITEM-701: SELECTION OF VIDEO/SYNC DELAY
To Prevent the Picture Shift in Switching Between
When Editing from VTR to VTR
Be sure to set the data No. of ITEM-701 for a recorder to
"0: SYNC DELAY".
1-10. Settings for External Editors
8 1: VIDEO DELAY
1-11