Door Assembly - Panasonic NE-C1275 Service Manual

NE-C1275 / NE-C1475
NOTE 1:
The membrane key board is attached to the escutcheon
base with double faced adhesive tape. Therefore,
applying hot air from A hair dryer is recommended for
smoother removal.
NOTE 2:
When installing new membrane key board, make sure
that the surface of escutcheon base is cleaned
sufficiently so that any problems (shorted contacts or
uneven surface) can be avoided.
NOTE 3:
Alignment position of membrane key board is as
follows (see figure);
Membrane key board: Right and lower edges
7.3. Power relays
NOTE:
Be sure to ground any static electric charge built up on
your body before handling the DPC.
NOTE:
Do not use a soldering iron or desoldering tool of more
than 30 watts on DPC contacts.
1. Using solder wick or a desoldering tool and 30W soldering
iron, carefully remove all solder from the terminal pins of the
power relays.
2. With all the terminal pins cleaned and separated from DPC
contacts, remove the defective power relay(s) and install
new power relay(s) making sure all terminal pins are
inserted completely.
carefully.
Resolder all terminal contacts
7.4.

Door assembly

1. Remove 2 screws holding the upper hinge to the oven.
2. Open the door and while pulling the door toward you, work
the upper hinge out through the hole in the oven.
3. Remove 4 screws holding the door C.
4. Remove the door C by carefully pulling outward starting
from the upper right hand corner.
5. Remove 2 screws holding door E.
16