Table of Contents
Advertisement
RECORDING
With the Arcam A32 it is possible to listen to and record from one
source, or to listen to one source while recording another.
Both sets of tape sockets are identical in sensitivity and suitable for use
with almost any type of recorder (cassette, CDR, MD, VCR, reel-to-
reel, etc.). The record signal is sent to both the
sockets.
3
RECORD
To record the currently selected source, press
shows 'RECORD SOURCE'. After a few seconds the display reverts to
showing the volume level and you are ready to record.
To listen to one source while recording another, press
until the display shows 'RECORD' followed by the name of an input (e.g.
'AUX', 'CD', 'TUNER', etc.). Now press the source selector button on the
front panel for the source you wish to record. Your selection is shown
on the display for a few seconds, after which it reverts to showing the
volume level and you are ready to record.
The
button can also be used as a second zone selector,
RECORD
sending a source signal at line level to a second amplifier operating in
another room. If you need help with this, contact your Arcam dealer
or Arcam customer support.
Tape-to-tape copying (dubbing)
You can perform tape dubbing from
.
VCR
For example, to copy from a cassette recorder connected to the
socket to a cassette recorder connected to the
button as explained above and select 'RECORD VCR'. This
the
RECORD
routes the VCR signal to the
TAPE
Set the cassette recorder connected to the
mode and the other to playback mode to start dubbing.
8
TAPE
To play back the recording from a cassette deck attached to the
input, press
. '
' is shown on the display. Selecting this input
TAPE
TAPE 1
overrides the other source selectors.
It is also possible to monitor a recording while it is being made,
provided your cassette deck is a 3-head type. To do this, press
Switching this button in/out allows an A/B comparison between the
source signal and the recorded signal.
and
output
TAPE
VCR
until the display
RECORD
RECORD
to
, but not from
VCR
TAPE
TAPE
socket, first use
TAPE 1
output.
socket into its record
TAPE
again
to
VCR
TAPE 1
.
TAPE
8
Advertisement
Table of Contents
