A28 Connections; Pre-/Power-Amplifier Connections; Recording Loop - Arcam FMJ A28 Handbook

A28
connections
Power inlet
Connect the correct
mains cable here.
�����������
Voltage select
Ensure the voltage selected matches
your local power supply.
This output provides a 12V signal whenever
the unit is switched on (i.e., not 'off ' or in
'stand-by'). This signal can be used to switch
on power amplifiers (or other equipment)
connected to the A28.
noTe
Please read the 'Placing the unit' , 'Power' and
'Interconnect cables' sections on page 5 before
connecting up your A28 integrated amplifier!
Speaker terminals
The A28 is equipped with two
sets of speaker terminals.
See page 8 for information on
connecting loudspeakers.
���
����������������
����
��� �����������
�������
������
������ ���
��
���������������� ����������������
Remote in
This allows remote-control signals to
be received by the A28 if the remote
sensor is covered (or otherwise not
'visible' to the remote-control).
See page 7 for more information.
Trig out

Pre-/power-amplifier connections

These sockets are only used if you are using the A28
as a pre-amp, for example, when using the A28 in
conjunction with a P38 in a bi-amplified system.
See page 9 for more information.
��
�
�
������� �������� ������ ���� ��� ��� ����� ��
��� ��
audio inputs
The labels below the inputs give suggested audio
inputs, although any suitable device may be
connected to the line-level inputs. (Note, however,
that the name of the input shown on the front-panel
display cannot be changed.)
DVD
The
see page 14 for the specification.
See page 7 for more information.

Recording loop

The A28 is equipped with
a recording loop for use
with recording devices (CD
recorders, cassette decks, etc.).
See pages 7 and 10 for more
information.
e-6
noTe
The and functions are only used
TRIG oUT REMoTE IN
in multi-room systems. They are not required for
normal use.
Phono earth terminal
For connecting your
turntable earth lead (if
required). Note that this
�����
���
���� terminal must not be used as
a safety earth.
, , , and are all line-level inputs.
SAT TUNER CD AUX
input has different characteristics –
phoNo (MM)