Using Your A32 Integrated Amplifi Er; Front Panel Controls - Arcam Handbook A32 Handbook

Using your A32 integrated amplifi er
1 5
MODE RECORD
2 3

FRONT PANEL CONTROLS

This section describes how to operate your amplifier.
If your amplifier has not been installed for you, you should first read
the section 'Installation: A32' on page 5.
POWER (and power indicator light)
Switches the unit on and off. (You can also switch the amplifier into
standby mode with the remote control handset.)
The light indicates the status of the amplifier. A red light means the
amplifier is in standby mode (press the
remote control, or the
POWER
between standby and powered-up modes).
8
Source selectors
These buttons select the source connected to the corresponding
input. A light above the relevant button indicates which input is
currently selected and it will also usually be shown on the display.
be used with a VCR or a second recording
Note that the VCR input may
unit (e.g. cassette deck).
9
TONE
Switches the tone circuits on and off, including settings for individual
sources. Note that the tone LED does not light unless a tone setting
has been made. (see page 8).
Control knob, SELECT and ENTER
The control knob has two functions:
as a volume control, to adjust the output of loudspeakers and
headphones connected to the amplifier, and of the pre-amp
output ( ).
PRE OUT
when used in conjunction with the
customise amplifier settings (see page 9).
Volume control settings
It is important to realise that the position of the volume control is not
an accurate indication of the power delivered to your loudspeakers.
The amplifier often delivers its full power long before the volume
control reaches its maximum position, particularly when listening
to heavily recorded compact discs. However the amplifier also has
to be capable of giving full power output from much lower level
sources, such as tuners and cassette decks. Using these sources, the
volume control setting may be much higher before distortion (audible
overload) sets in. To compensate for this, the input levels of each
source may be individually adjusted to avoid accidental overload (see
page 9).
6
ENTER
SELECT
4 7
bm
button on the
POWER/STANDBY
button on the front panel, to switch
746
and buttons, to
SELECT ENTER
PHONO/AUX CD TUNER AV DVD
8
bk
SP1 and SP2
These buttons allow you to select and deselect the main (
secondary ( ) set of speakers attached to your amplifier.
SP2
The light above each button glows if the corresponding speakers
are currently selected. If both lights are out the amplifier will appear
not to work, as all speakers are switched off! If both are on, with
two pairs of low impedance speakers connected, overloads are more
likely. Overloading the amplifier may cause it to shut down because of
overheating.
bl
PHONES
This socket accepts headphones with an impedance rating between
8 and 2k , fitted with a 1/4-inch stereo jack plug. If you wish to listen
on headphones only, use the
the speakers.
The headphone socket is always active. To avoid possible damage,
always disconnect headphones prior to switching the amplifier on or
off.
Remote control receiver
The remote control's infrared receiver is positioned behind the 'FMJ'
badge. Ensure the receiver is in a clear line of sight from the remote
control to allow signals to be received.
MODE, UP and DOWN
These buttons are mainly for use with future optional modules,
however the
UP
amplifier to move the cursor when customising the 'Welcome message'
(see page 9).
7
A32 INTEGRATED AMPLIFIER
VCR TAPE TONE SP1 SP2
9 bk
and buttons (if necessary) to mute
SP1 SP2
1
2 5
and buttons are used with the basic A32
DOWN
PHONES POWER
bl bm
) and
SP1