Table of Contents
Advertisement
Setting up your A32 integrated amplifi er
'Switch on'
state
DOWN
UP
VOLUME
Adjust
LEFT
RIGHT
BALANCE
Adjust
–dB
+dB
BASS
Adjust
–dB
+dB
TREBLE
Adjust
Customize ->
Choose
setting
Volume
VOLUME
Resolution
DISPLAY
edit
edit
STANDARD
FINE
REFERENCE
continue
Volume Resolution
Volume Display
Volume Resolution – Standard, fine
or Reference. 'Standard' and 'Fine' represent
different levels of volume control sensitivity. The
'Reference' setting gives absolute increments in
0.5dB steps.
Volume display mode – graphic or
numeric shows the volume either as a bar
graph or as a number. If Volume resolution is
set to 'Reference' a numeric volume display
shows the actual decibel figure.
INTRODUCTION
The A32 allows you to adjust listening settings
to suit your taste, and to customize various
features of the amplifier to fit your system.
Use this diagram to help you navigate through
the settings available.
The
ENTER
in the diagram by the symbols
respectively.
The Control knob is shown as
INPUT
TRIMS
edit
GRAPHIC/
TRIM
NUMERIC
continue
continue
Input Trims
Input Trims – use the source select buttons
and Control knob to set input trims for each
source. Input trims are used to compensate
for variations in output levels of different
source equipment.
Tone Control – Global or Per source.
This specifies the scope of changes for 'Bass'
and 'Treble' tone settings. The default setting
is 'Global' which affects all inputs equally.
'Per source' allows you to set tone controls
for individual inputs: once set, the amplifier
remembers tone settings for each input.
Welcome message – You can change the power
on Welcome message from '
display your name, postcode, etc. When customising
the message, use the
select the cursor position and the Control knob to
change the letter.
and
buttons are represented
SELECT
and
.
TONE
WELCOME
CONTROL
MESSAGE
edit
edit
GLOBAL/
ARCAM Amp
PER
SOURCE
continue
Tone Control
Welcome Message
Arcam Amp'
and
buttons to
UP
DOWN
9
ADJUSTING LISTENING
SETTINGS
The default display mode is VOLUME, where
the control knob is used to adjust sound level.
Press
to enter edit mode and cycle
SELECT
through the other sound settings: BALANCE,
BASS and TREBLE. When a setting is selected,
adjust it with the control knob. Press
fix the change you have made and return to
default (volume) mode, or press
to move to the next setting.
CUSTOMISING AMPLIFIER
SETTINGS
Press
until
SELECT
'CUSTOMIZE->'. Now rotate the Control knob
to choose which setting you wish to alter.
Press
to adjust the chosen setting with
SELECT
the Control knob.
Press
to confirm the adjustment or
ENTER
press
to confirm the adjustment and
SELECT
move on to the next item.
Press
twice to leave the Customize
ENTER
menu.
PHONO/AUX
TEXT
edit
AUX/
PHONO
continue
continue
Phono/Aux Text
Phono/Aux Text – If you have had the
optional
Phono module added, choose
'Phono' so this word is displayed when the
input is selected. The default is 'Aux'.
Restore Settings – this restores all amplifier
settings, including Input trims and the Welcome
message, to their factory defaults.
to
to
ENTER
again
SELECT
the
display
shows
RESTORE
SETTINGS
edit
NO/YES
'Switch on'
state
Restore Settings
Advertisement
Table of Contents
