Error Messages - Panasonic KX-TG4381NZ Operating Instructions Manual

TG43xxNZ(e)_OI.book Page 43 Tuesday, August 26, 2008 1:58 PM

Error messages

If the unit detects a problem, one of the following messages is shown on the display.
Display message Cause/solution
L The called handset
Busy
L Another handset is in use and the system is busy. Try
or
L The handset you are using is too far from the base unit.
System is busy.
Please try again
L The handset's registration may have been cancelled.
later.
L The supplied telephone line cord has not been
Check tel line
L Dial lock is turned on. To turn it off, see page 19.
Dial locked
L A wrong type of batteries such as Alkaline or
Don't use this
battery.
L The handset's registration has failed. Move the handset
Error!!
L The entered password was wrong in programming dial
L The handset was placed on the base unit or charger
Insert battery
L There is no handset registered to the base unit matching
Invalid
L The handset is not registered to the base unit. Register
L The handset has lost communication with the base unit.
No link to base.
Reconnect AC
adaptor.
L Unplug the base unit's AC adaptor to reset the unit.
L The handset's registration may have been cancelled.
L The phonebook memory is full. Erase unnecessary
Phonebook full
Store VM access# L You have not stored the voice mail access number.
*1 KX-TG4382/KX-TG4392
*2 KX-TG4391/KX-TG4392
*1
or base unit
*1
again later.
Move closer and try again.
Re-register the handset (page 48).
connected yet or not connected properly. Check the
connections (page 12).
Manganese was inserted. Use only the rechargeable Ni-
MH batteries noted on page 5, 13.
and base unit away from all electrical appliances and try
again.
lock. Enter the correct password.
without batteries. Insert the batteries properly (page 13).
the handset number you entered.
the handset (page 48).
Move closer to the base unit and try again.
Reconnect the adaptor and try again.
Re-register the handset (page 48).
entries (page 21).
Store the number (page 37).
Useful Information
*2
is in use.
43