Camera Set Menu; Camera Id; V-Sync; Color - EverFocus ED2250S/P Owner's Instructions Manual

1. CAMERA SET MENU

CAMERA ID

The CAMERA ID menu assigns an ID to the ED2250S/P to be displayed
on the connected monitor.On the CAMERA SET menu screen, select
CAMERA ID to ON and press [Enter]. You will see the sub screen for
deciding on the ID of the ED2250S/P. The Camera ID can have up to 12
alphanumeric characters, along with several special characters.
The assigned camera ID may be positioned to any desired location on the
screen by using the LOCATION submenu.
(CAMERA ID)
(CAMERA SET)
A B C D E F G H I J K L
CAMERA ID ON... ➜
M N O PQ R S T U V W X

V-SYNC

INT
COLOR/BW

COLOR

Y Z 0 1 2 3 4 5 6 7 8 9
ZOOM SPEED 3 : ! - +
Press [Enter]
MOTION DET OFF SP
LOCATION...
RET
............
EXIT QUIT
* " ... " Means there are Sub Menus.
V-SYNC
In the V-SYNC menu, vertical
synchronization can be selected. The vertical
synchronization signal supported by the
ED2250S/P is the INT mode made by clock
inside the ED2250S/P and LINE mode
adjusting vertical synchronization to the
exterior power frequency.
3-4
✽
( ) /
ï î SP
(CAMERA SET)
CAMERA ID OFF
V-SYNC INT
COLOR/BW COLOR
ZOOM SPEED 3
MOTION DET OFF
EXIT QUIT
Select LINE and press [Enter]. You will see the LINE LOCK submenu
where you can adjust the phase of the LINE LOCK.
You can use the PHASE menu of the LINE LOCK submenu to assign as
much PHASE as you want.
(LINE LOCK)
(CAMERA SET)
➜
CAMERA ID OFF
V-SYNC LINE...
Press
COLOR/BW COLOR
ZOOM SPEED 3
[Enter]
MOTION DET OFF
PHASE ( 000)
EXIT QUIT RET
COLOR/BW
(CAMERA SET)
In the COLOR/BW menu, you can switch ON or OFF
the IR (infrared) Filter. CAMERA ID
V-SYNC
In low light conditions, IR Filter is turned OFF to the BW
COLOR/BW
ZOOM SPEED
Mode and the sensitivity to low light increases to that of
MOTION DET
a black and white camera. In bright light conditions, the
IR Filter is turned ON to the COLOR Mode, and the
EXIT
screen changes to normal as the sensitivity decreases.
COLOR : The IR Filter is ON and the screen is normal.
BW : The IR Filter is OFF and the screen is black and white.
(Sensitivity to low light is increased to a level comparable to a black and
white camera.)
AUTO : Depending on the intensity of light, the mode automatically switches
between the COLOR Mode and the BW Mode.
In low light conditions, the IR Filter is turned OFF to switch to the BW
Mode to increase the sensitivity to low light, but in bright light conditions,
the IR Filter is turned ON to switch to the COLOR Mode to decrease the
sensitivity.
If you select AUTO and press the [ENTER] key, the BW LEVEL submenu
screen where you can adjust the BW LEVEL will be displayed. In the BW
LEVEL submenu, you can adjust the brightness level that changes from
the COLOR Mode to BW Mode in 3 steps, LOW, MEDIUM, and HIGH.
(CAMERA SET)
➜
CAMERA ID OFF
V-SYNC INT
COLOR/BW AUTO...
Press
ZOOM SPEED 3
MOTION DET OFF
[Enter]
EXIT QUIT
---- I ---- E
OFF
INT
COLOR
3
OFF
QUIT
(BW LEVEL)
LEVEL MEDIUM
RET
3-5