D-Link xStack DES-3528 series User Manual page 259
Layer 2 managed stackable fast
Hide thumbs
Also See for xStack DES-3528 series:
- Cli reference manual (605 pages) ,
- Reference manual (378 pages) ,
- User manual (318 pages)
Table of Contents
Advertisement
®
xStack
DES-3528/DES-3552 Series Layer 2 Stackable Fast Ethernet Managed Switch User Manual
srTCM – Single Rate Three Color Marker, marks packets green, yellow or red based on a rate
and two burst sizes. This is useful when only burst size matters.
Action
Conform – Specifies the action when the packet is in "green color" mode.
Exceed – Specifies the action when the packet is in "yellow color" mode.
Violate – Specifies the action when the packet is in "red color" mode.
Click Apply to implement changes made, click Back to return to the ACL Flow Meter.
•
PIR (64Kbps) – Specifies the Peak Information Rate of the packet. Tha range is from 0
to 15624. The unit is 64Kbps. That is to say, 1 means 64Kbps.
•
CBS (Kbyte) – Specifies the Committed Burst Size of the packet. Tha range is from 0 to
16384. The unit is Kbyte. That is to say, 1 means 1Kbyte. This parameter is optional and
the default value is 4*1024. The max value is 16*1024.
•
PBS ( Kbyte) – Specifies the Peak Burst Size of the packet. Tha range is from 0 to
16384.The unit is Kbyte. That is to say, 1 means 1Kbyte. This parameter is optional and
the default value is 4*1024. The max value is 16*1024.
•
CIR (64Kbps) – Specifies the Committed Information Rate of the packet. Tha range is
from 0 to 15624. The unit is 64Kbps. That is to say, 1 means 64Kbps.
•
CBS (Kbyte) – Specifies the Committed Burst Size of the packet. Tha range is from 0 to
16384. The unit is Kbyte. That is to say, 1 means 1Kbyte. This parameter is optional and
the default value is 4*1024. The max value is 16*1024.
•
EBS (K byte) – Specifies the Excess Burst Size of the packet. Tha range is from 0 to
16384. The unit is Kbyte. That is to say, 1 means 1Kbyte. The maximum value is
16*1024.
•
Replace dscp – Change the dscp of the packet.
•
Counter - Specifies the counter. This is optional. The default is Disabled.
•
Permit – Permits the packet.
•
Replace DSCP – Allows you to change the DSCP of the packet.
•
Drop – Drops the packet.
Counter - Specifies the counter. This is optional. The default is Disabled.
•
•
Permit – Permits the packet.
•
Replace DSCP – Change the DSCP of the packet.
•
Drop – Drops the packet.
•
Counter - Specifies the counter. This is optional. The default is Disabled.
258
Advertisement
Table of Contents
