Completing The Parts Replacement - Lenovo THINKSTATION 7783 Hardware Maintenance Manual

7. Pull on the tips of the rubber mounts until the rear fan assembly is secured in place.
Figure 36. Installing the rear fan assembly
8. Connect the rear fan assembly cable to the rear fan connector on the system board. See "Locating
parts on the system board" on page 71.
What to do next:
• To work with another piece of hardware, go to the appropriate section.
• To complete the installation or replacement, go to "Completing the parts replacement" on page 102.

Completing the parts replacement

After completing the installation or replacement for all parts, you need to reinstall the computer cover and
reconnect cables. Depending on the parts you installed or replaced, you might need to confirm the updated
information in the Setup Utility program. Refer to Chapter 6 "Using the Setup Utility program" on page 37.
To reinstall the computer cover and reconnect cables to your computer, do the following:
1. Make sure that all components have been reassembled correctly and that no tools or loose screws
are left inside your computer. See "Locating components" on page 70 for the locations of various
components in your computer.
2. If you have removed the front bezel, reinstall it. See "Removing and reinstalling the front bezel" on
page 73.
102
ThinkStation Hardware Maintenance Manual