Symptom-To-Fru Index; Numeric Error Codes - Lenovo THINKPAD X100E Hardware Maintenance Manual

Symptom-to-FRU index

This section contains following information:
v "Numeric error codes"
v "Error messages" on page 55
v "No-beep symptoms" on page 55
v "LCD-related symptoms" on page 56
v "Intermittent problems" on page 57
v "Undetermined problems" on page 57
The symptom-to-FRU index in this section lists symptoms and errors and their
possible causes. The most likely cause is listed first, in boldface type.
Note: Do the FRU replacement or other actions in the sequence shown in the
column headed "FRU or action, in sequence." If replacing a FRU does not solve
the problem, put the original part back in the computer. Do not replace a
nondefective FRU.
This index can also help you determine, during regular servicing, what FRUs are
likely to need to be replaced next.
A numeric error is displayed for each error detected in POST or system operation.
In the displays, n can be any number.
If no numeric code is displayed, check the narrative descriptions of symptoms. If
the symptom is not described there, go to "Intermittent problems" on page 57.

Numeric error codes

52
ThinkPad X100e Hardware Maintenance Manual
Note:
For a device not supported by diagnostic codes in the ThinkPad Notebooks, see
the manual for that device.
Table 2. Numeric error codes
Symptom or error (beeps, if any)
0187
EAIA data access error—The access to
EEPROM is failed.
(two short beeps)
0189
Invalid RFID configuration information
area—The EEPROM checksum is not correct.
(two short beeps)
0190
Critical low-battery error
(two short beeps)
0191
System Security—Invalid Remote Change
requested.
0210
Stuck Key
(two short beeps)
FRU or action, in sequence
System board.
System board.
1. Charge the battery pack.
2. Battery pack.
1. Run BIOS Setup Utility, and then save
current setting by pressing F10.
2. System board.
Change keyboard, and restart the computer.