Hard Disk Data Erase Utility - Panasonic CF-T8 Operating Instructions Manual

Hard Disk Data Erase Utility

When disposing the computer or transferring the ownership, erase all hard disk data in order to avoid data leakage.
Even if you erase the data or initialize the hard disk using normal Windows commands, the data can be read with some
special software. Use the hard disk data erase utility to erase the data completely.
Note that transferring of the ownership without uninstalling the commercial software will be a violation of the software's
license agreement.
The hard disk data erase utility erases data using an overwriting method, but there is a possibility that due to malfunc-
tions or other operational errors, data may not be completely erased. There are also specialized devices that may be
able to read data that has been erased using this method. If you need to erase highly confidential data, we recom-
mend that you contact a company that specializes in this process. Panasonic Corporation will bear no responsibility
for losses or damages suffered as a result of the use of this utility.
NOTE
This utility cannot erase data for specific partitions. The entire hard disk data including the data of the recovery parti-
tion will be erased.
It will take 2 to 6 hours to erase the data. (Erasing time varies depending on the capacity of the hard disk.)
Preparation
Prepare the Product Recovery DVD-ROM for Windows Vista (included).
Prepare the Panasonic CD/DVD drive (optional): CF-VDRRT1M, CF-VDRRT2W, CF-VDRRT3W,
CF-VDRRT3U.
Remove all peripherals (except for the CD/DVD drive).
Connect the AC adaptor and do not remove it until hard disk data erase is complete.
1 Turn off the computer and connect the CD/DVD drive to the computer.
2 Turn on the computer, and press
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
3 Press .
F9
At the confirmation message, select [Yes] and press Enter.
4 Press .
F10
At the confirmation message, select [Yes] and press Enter.
The computer will restart.
5 Press or
F2
The Setup Utility starts up.
If the password is requested, enter the Supervisor Password.
6 Set the Product Recovery DVD-ROM for Windows Vista into the CD/DVD drive.
7 Select the [Exit] menu, then select your CD/DVD drive in [Boot Override].
8 Press
Enter
The computer restarts.
If [Enter Password] is displayed during the following procedures, input the Supervisor Password or the User
Password.
9 Click [Erase the whole data on the Hard Disk for security] and click [Next].
10 At the confirmation message, click [YES].
11 Click [Continue].
12 Click [Continue] again.
13 Click [YES].
Erasing the hard disk data starts.
14 After erasing is completed, remove the Product Recovery DVD-ROM and click [OK].
26
while [Panasonic] boot screen is displayed.
Del
.
or while [Panasonic] boot screen is displayed.
F2 Del