Lenovo THINKCENTRE 3317 Hardware Maintenance Manual page 79

3. Locate the memory slots. See "Locating parts on the system board" on page 70.
4. Open the retaining clips.
Figure 7. Opening the retaining clips
If you are replacing an old memory module, open the retaining clips and remove the memory module
being replaced as shown.
Figure 8. Removing the memory module
5. Position the memory module over the memory slot. Make sure that the notch
aligns correctly with the slot key
the slot until the retaining clips close.
2 on the system board. Push the memory module straight down into
1 on the memory module
.
Chapter 8 Replacing FRUs
73