Configuration Menu (Config Menu); Entering Configuration Menu; Available Menus; Maint Cnt Value - Lexmark E350d Service Manual

4512-420, -430

Configuration menu (CONFIG MENU)

Entering Configuration Menu

1.
Turn off the printer.
2.
Press and hold
3.
Turn on the printer.
4.
Release the buttons when Performing Self Test displays.
The message CONFIG MENU displays on the top line of the operator panel.

Available menus

Maint Cnt Value

Reset Maint Count

Reset PC Count
Prt Quality Pgs
Panel Menus
PPDS Emulation
Demo Mode
Factory Defaults
Energy Conserve
Event Log
Reduced Curl
USB Speed
Exit Config Menu
Menus may vary depending on the features and options of the printer.
Maint Cnt Value
This value represents the number of printed sides (duplexed=2 sides). It can be reset via Reset Maint Count.
Reset Maint Count
To reset the Maint Cnt Value:
1.
Select Reset Maint Count from the CONFIG MENU.
2.
Press to reset the counter.

Reset PC Cnt

When you install a new photoconductor, this number should be reset.
To reset the counter:
1.
Select Reset PC Cnt from the CONFIG MENU.
2.
Press to reset the counter to zero.
Note: Permanent page count is not affected by this operation.
3-2
Lexmark™ E350d, E352dn
and Back .
"Maint Cnt Value" on page
"Reset Maint Count" on page
"Reset PC Cnt" on page
"Print quality pages (Prt Quality Pgs)" on page
"Panel Menus" on page 3-3.
"PPDS Emulation" on page
"Demo Mode" on page 3-3.
"Factory Defaults" on page
"Energy Conserve" on page
"Event Log" on page 3-3.
"Reduced Curl" on page
"USB Speed" on page 3-4.
"Exit Config Menu" on page
3-2.
3-2.
3-2.
3-3.
3-3.
3-3.
3-3.
3-4.
3-4.