Door Assembly - Electrolux EIGD55H Technical & Service Manual

This section will describe how to access and
remove serviceable components from the dryer.
Unless stated, the procedure will be the same on
all models. Unless stated, reverse the procedure
to reinstall the component.
D D o o o o r r C C o o m m p p o o n n e e n n t t s s
D D o o o o r r T T r r i i m m R R i i n n g g R R e e m m o o v v a a l l
The door is secured to a hinge assembly mounted
to the unit frame. The trim ring must be removed
to access and remove the hinge assembly.
To remove the door assembly:
1. Open the door to a 90 degree angle.
2. Using a #2 square bit screwdriver, extract
and save the trim plug and long, course
thread, panhead screw. (See Figure 4-1)
3. Close the door.
4. Rotate the door trim approximately ¾"
counter-clockwise and pull it away from the
front of the door. (See Figure 4-2)
D D o o o o r r A A s s s s e e m m b b l l y y R R e e m m o o v v a a l l
The door assembly is secured with 4 screws to the
hinge assembly. It is not necessary to remove the
trim ring to access the hinge screws of the door
assembly.
To remove the door assembly:
1. Open the door to a 90 degree angle.
2. Using a #2 square bit screwdriver, extract
the 4 long, course thread, countersunk
hinge screws from door. (See Figure 4-3)
3. While supporting the weight of the door with
both hands, separate the door from the hinge.
(See Figure 4-4)
4. Gently place the door face down on a flat,
covered work surface.
C C o o m m p p o o n n e e n n t t T T e e a a r r d d o o w w n n
Trim Plug
F F i i g g u u r r e e 4 4 - - 1 1 . .
Trim Ring
F F i i g g u u r r e e 4 4 - - 2 2 . .
Door Hinge Screws
F F i i g g u u r r e e 4 4 - - 3 3 . .
4-3