Electrolux EIGD55H Technical & Service Manual page 31

R R e e a a t t t t a a c c h h i i n n g g S S t t r r i i k k e e r r P P l l a a t t e e
1. Rotate the striker plate and move it to the
opposite side of door above the indicator.
2. Reattach with 2 long, course-thread,
counter-sunk screws. (See Figure 2-41)
F F i i g g u u r r e e 2 2 - - 4 4 1 1 . .
R R e e i i n n s s e e r r t t i i n n g g H H o o l l e e P P l l u u g g
1. Rotate the hole plug and move it to the
opposite hole in the door.
2. Grasp the hole plug between finger and
thumb and insert the tab into the retaining
slot. (See Figure 2-42)
3. Pivot the hole plug downward toward the
center of the glass until it is in place.
F F i i g g u u r r e e 2 2 - - 4 4 2 2 . .
I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n
R R e e a a t t t t a a c c h h i i n n g g D D o o o o r r A A s s s s e e m m b b l l y y
1. Open the hinge to a 90 degree angle.
2. Install the door onto the hinge locating pins.
(See Figure 2-43)
3. Secure the door with 4 long, course-thread,
counter-sunk screws. (See Figure 2-44)
4. Close the door and test the operation of the
latch.
F F i i g g u u r r e e 2 2 - - 4 4 3 3 . .
F F i i g g u u r r e e 2 2 - - 4 4 4 4 . .
2-21