Lenovo ThinkServer RD440 User Manual And Hardware Maintenance Manual page 178

• "Installing or replacing the ThinkServer RAID Super Capacitor Module on the cooling shroud" on page 166
• "Installing or replacing the ThinkServer RAID Super Capacitor Module on the riser card assembly
2" on page 169
Installing or replacing the ThinkServer RAID Super Capacitor Module on the cooling
shroud
Before you begin, print all the related instructions or ensure that you can view the PDF version on another
computer for reference.
Notes:
• Depending on the model, your server might look slightly different from the illustrations in this topic.
• Use any documentation that comes with the ThinkServer RAID Super Capacitor Module and follow those
instructions in addition to the instructions in this topic.
To install or replace the ThinkServer RAID Super Capacitor Module on the cooling shroud, do the following:
1. Remove all media from the drives and turn off all attached devices and the server. Then, disconnect all
power cords from electrical outlets and disconnect all cables that are connected to the server.
2. If the server is installed in a rack cabinet, remove the server from the rack cabinet and place it on a flat,
clean, and static-protective surface. See the Rack Installation Instructions that comes with the server.
3. Remove the server cover. See "Removing the server cover" on page 89.
4. If you are installing the ThinkServer RAID Super Capacitor Module, go to step 5.
If you are replacing the ThinkServer RAID Super Capacitor Module, do the following:
a. Disconnect the cable of the ThinkServer RAID Super Capacitor Module from the PCI Express card.
Press the tab 1
when you lift the bracket. Then, remove the bracket with the ThinkServer RAID Super Capacitor
Module as shown.
Figure 122. Removing the ThinkServer RAID Super Capacitor Module with the bracket from the cooling shroud
166
ThinkServer RD440 User Guide and Hardware Maintenance Manual
slightly outward to ensure that it can smoothly pass through the hole in the bracket