Lenovo ThinkServer RD440 User Manual And Hardware Maintenance Manual page 165

8. Align the screw holes in the drive adapter and the solid-state drive with the corresponding holes in the
drive bracket. Then, install the five screws to secure the drive adapter and the solid-state drive to
the bracket.
Figure 104. Installing the screws to secure the drive adapter and the solid-state drive to the bracket
9. Slide the bracket with the solid-state drive into the drive bay from the front until it snaps into position
and then completely close the handle.
Figure 105. Installing the bracket with the solid-state drive
10. Check the hard-disk-drive status LEDs to ensure that the solid-state drive is operating correctly. You
might have to restart the server for the newly installed solid-state drive to be recognized. See "Hot-swap
P S
U
M e
m
C P
U
.
Chapter 6 Installing, removing, or replacing hardware
153