Panasonic Toughbook CF-27 Series Reference Manual page 41

Personal computer
Hide thumbs Also See for Toughbook CF-27 Series:
Table of Contents

Advertisement

Dealing With Problems
Connecting Peripherals
Your peripheral does not
work (An error occurs
while installing the driver)
Unable to print
The cursor does not
move from mouse opera-
tions
The device connected to
the serial port does not
work
E x t e r n a l m o u s e o r
trackball connected to the
external keyboard/mouse
port does not work
A PC Card does not work
You do not know the
available RAM module
The RAM module has not
been recognized
The address map for
IRQ, I/O port address,
etc. is unclear
A USB device does not
work
"Installation Error" is
displayed
IrDA does not work
Some devices do not
work
You need to use drivers conforming to the current operating system.
Some earlier drivers will no longer work.
For more information, please ask the manufacturer of the driver in question.
Press F9 in the Setup Utility.
Check the computer-printer connection.
Make sure the printer is on.
Make sure the printer is in the online state.
Make sure paper is in the printer tray and there is no paper jam.
Has the Setup Utility been used to set [Parallel Port] to [Enable]?
Check your mouse connection, then reboot the computer from the keyboard.
From the keyboard, you may choose to press down on
Down].
Check the connection.
Confirm that the device driver for the serial port works. Please refer to the refer-
ence manual of the device.
Confirm that two mouse devices are not connected, one through the external key-
board/mouse port and the other through the serial port.
Confirm that [Device] is set to [Port Replicator] in the Setup Utility.
Try setting [Touch Pad] to disable in the Setup Utility.
Has the Setup Utility been used to set [Serial Port] to [Enable]?
Try setting [Touch Pad] to disable in the Setup Utility.
In some circumstances, if a PS/2 external mouse with a serial interface conver-
sion function is connected to the port, it may not operate normally. Try connecting
it to the serial port.
Make sure the card is properly inserted.
Confirm that the card conforms to the PC Card Standard.
Note that after a driver is installed, the computer must be rebooted.
Check that the proper port settings have been made.
Read the PC Card's manual. Or, you may need to call the manufacturer of the PC
Card.
When [Card Executive 2.0 for NT] is not displayed in [Control Panel], install Phoe-
nix Card Executive™ 2.0 for Windows NT
Confirm that a PC Card compatible with Windows NT is being used.
Confirm that [Get Default Values] has been set in the Setup Utility.
page 22
Make sure the RAM module has been properly inserted.
Use the RAM module that support the recommended specifications.
Select [Start] - [Programs] - [Administrative Tools] - [Windows NT Diagnostics] to see
the present conditions.
USB devices are not supported.
Has the Setup Utility been used to set [Internal CardBus Controller] to [Disable]?
Separate communications software is necessary.
Press F9 in the Setup Utility (
®
.
page
27).
41
, then select [Shut

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents