Wind The Bobbin - Janome 2049 Service Manual

1. PULL THE HANDWHEEL OUT.
2. DRAW THE THREAD FROM THE SPOOL THROUGH THE BOBBIN WINDING TENSION
DISCS (A).
3. PULL THE END OF THE THREAD THROUGH THE BOBBIN AS SHOWN.
PLACE THE BOBBIN ONTO THE BOBBIN WINDING SPINDLE, (B) WITH THE END OF
THE THREAD COMING FROM THE TOP OF THE BOBBIN.
PUSH THE BOBBIN WINDING SPINDLE TO THE RIGHT UNTIL IT CLICKS.
4. HOLDING THE END OF THREAD, START THE MACHINE. WHEN THE BOBBIN IS
SLIGHTLY FILLED, SNIP OFF THE END OF THE THREAD.
5. WIND THE THREAD UNTIL THE BOBBIN STOPS. REMOVE THE BOBBIN.
6. PUSH THE HANDWHEEL TO THE LEFT.
A
1 PLACE THE BOBBIN IN THE
BOBBIN CASE MAKING SURE
THE THREAD FEEDS
CLOCKWISE, AND IS COMING
FROM THE BOBBIN AS SHOWN.
4 HOLDING THE LATCH OPEN,
POSITION THE CASE INTO THE
SHUTTLE AND RELEASE THE
LATCH.

WIND THE BOBBIN

B
2 PULL THE THREAD THROUGH
THE SLOT OF THE CASE AS
SHOWN.
5 THE CASE SHOULD LOCK INTO
PLACE WHEN THE LATCH IS
RELEASED.
2
3 PULL THE THREAD UNDER THE
TENSION SPRING, AND THROUGH
THE OPENING AS SHOWN ABOVE.