Adjusting The Bobbin Winder Switch - Janome 7330 Servicing Manual

ADJUSTING THE BOBBIN WINDER SWITCH

TO ADJUST THE BOBBIN WINDING SWITCH
1. Remove the front cover (see page 7).
2. Set the bobbin winder arm in the sewing position and loosen the setscrew.
Adjust the clearance between the bobbin winder arm and the switch fixing plate to o.7 to 1.3 mm.
3. Tighten the setscrew.
4. Install the front cover.
TO CONFIRM:
Turn the power switch on.
The led displays
bobbin winder is returned to the sewing position.
Setscrew
Switch fixing
plate
when the bobbin winder spindle is set the bobbin winding position, and
Approx.
07. To 1.3 mm
Bobbin winder arm
(Bobbin winding)
35
7330
when the