Interface General Commands Summary; Basic Interface Properties And Ip Address Commands - ZyXEL Communications ZYWALL USG Series Reference Manual

13.2 Interface General Commands Summary

The following table identifies the values required for many of these commands. Other input values
are discussed with the corresponding commands.
Table 36 Input Values for General Interface Commands
LABEL
interface_name
profile_name
domain_name
The following sections introduce commands that are supported by several types of interfaces. See
Section 13.6 on page 105

13.2.1 Basic Interface Properties and IP Address Commands

This table lists basic properties and IP address commands.
Table 37 interface General Commands: Basic Properties and IP Address Assignment
COMMAND
show interface {ethernet | vlan | bridge
| ppp} status
show interface {interface_name | ethernet
| vlan | bridge | ppp | virtual ethernet |
virtual vlan | virtual bridge
show ipv6 interface {interface_name |
all}
show ipv6 static address interface
show ipv6 nd ra status config_interface
ZyWALL / USG (ZLD) CLI Reference Guide
DESCRIPTION
The name of the interface.
Ethernet interface: For some ZyWALL / USG models, use gex, x = 1 - N, where N equals
the highest numbered Ethernet interface for your ZyWALL / USG model.
For other ZyWALL / USG models use a name such as wan1, wan2, opt, lan1, ext-
wlan, or dmz.
virtual interface on top of Ethernet interface: add a colon (:) and the number of the
virtual interface. For example: gex:y, x = 1 - N, y = 1 - 4
VLAN interface: vlanx, x = 0 - 4094
virtual interface on top of VLAN interface: vlanx:y, x = 0 - 4094, y = 1 - 4
bridge interface: brx, x = 0 - N, where N depends on the number of bridge interfaces
your ZyWALL / USG model supports.
virtual interface on top of bridge interface: brx:y, x = the number of the bridge interface,
y = 1 - 4
PPPoE/PPTP interface: pppx, x = 0 - N, where N depends on the number of PPPoE/PPTP
interfaces your ZyWALL / USG model supports.
The name of the DHCP pool. You may use 1-31 alphanumeric characters,
underscores( ), or dashes (-), but the first character cannot be a number. This value is
_
case-sensitive.
Fully-qualified domain name. You may up to 254 alphanumeric characters, dashes (-), or
periods (.), but the first character cannot be a period.
for the unique commands for each type of interface.
DESCRIPTION
Displays the connection status of the specified type of interfaces.
Displays information about the specified interface, specified type of
interfaces, or all interfaces. See
possible cellular status description.
| all}
Displays information about the specified IPv6 interface or all IPv6
interfaces.
Displays the static IPv6 addresses configured on the specified IPv6
interface.
Displays the specified IPv6 interface's IPv6 router advertisement
configuration.
Chapter 13 Interfaces
Section 13.6.1 on page 107 for all
85