Testing Stitch Overlock Stitches - Husqvarna Viking H Class 200S User Manual

TESTING STITCH OVERLOCK STITCHES

After threading is completed, use a scrap of fabric that you plan to sew and test sew in the
following order:
1. Gently pulling all the threads to the left, lower the presser foot. Rotate the hand wheel
toward you a few times to see if the lock stitches are properly formed.
2. Start the machine at low speed and feed in test fabric under the presser foot by slightly
pushing it forward. (This can be done with the presser foot down on most fabrics except
bulky materials.) Guide the fabric gently as machine automatically feeds the material.
3. Check thread tensions by test sewing on a scrap of fabric.
4. At the fabric end, continue running the machine at a low speed, gently pulling the fabric
towards the back until about 2" (5 to 6 cm) of extra stitches are produced off the fabric.
Cut thread by pushing thread cutter lever down, or use scissors.
28
FIG. 1
FIG. 2
FIG. 3