Husqvarna Viking H Class 200S User Manual page 18

CUTTING WIDTH GAUGE
Use the cutting width gauge to assure the fabric is cut and sewn consistently. Adjust the width
gauge for the desired seam allowance.
THREAD CUTTER
Thread cutter is built in to the needle plate. Trim thread near the end of fabric by pushing
down the lever as illustrated.
CHANGING PRESSER FEET
Be sure needle is in the up position. Raise presser foot lever.
1. Push foot release lever to remove the foot.
2. Place the desired foot on the needle plate aligning needle holes.
3. Lower the presser foot lever and push foot release lever so that the foot holder snaps on
the foot.
CHANGING NEEDLE
Raise needle bar to its highest point by turning hand wheel towards you, but leave presser foot
down. Loosen needle clamp screw to remove the needle, and place new needle with flat side
away from you, into the needle bar as far as it will go, and tighten screw.
Illustration
* : Foot release lever
I
* : Needle clamp screw
II
* : Flat side away from you.
III
16
*I
*II
*III