Husqvarna Viking H Class 200S User Manual page 24

THREADING UPPER LOOPER
1. Feed the thread through the thread guide as illustrated.
2. Pull the thread through the slot. Holding the thread with your left hand, pull down
with right hand firmly.
3. Draw the thread through the thread guide as illustrated.
(When threading according to the instructions, upper looper thread passes the thread
guide (A) automatically after turning the hand wheel.)
4. Pass the thread through the thread guide and looper eye. Pull an excess thread length
of about 4" (10 cm) above the needle plate and behind the presser foot.
22